OS7400 v4.14 071112

[Wi$e]

http://www.officeats.ru/product_info.ph ... ml?fid=444
http://samsungpbx.mylivepage.ru/file/32 ... 4_4.14.rar

[Wi$e]

MP40 S/W: V4.14 (07.11.15):
Added Features & Modified items
- ATRK -> UMS TSW gain value is changed
- Refer to the attached 1Q Problem List (check 1Q number started with ‘N’)

LP40 SW v1.17 – 07.11.12
Change Notes
1. MW feature is available on 16SLI2/8SLI2/8COMBO2.
=> In Italy, Spain and France, MW feature was not working. We add MW feature based on PRS.
2. RCM2 D'bd on LOC 1 was not working.
=> If RCM2 on LOC 1 is initialized with no delay, channels of RCM2 are not working.
We add interval time to D'bd initial phase.
3. When using LP40 (V1.16) and MP40 (V3.34), CID feature is not working
=> Because CID parameters have been downloaded after V1.16, the default A-law/u-law setting value according to nation is eliminated. We set A-law, u-law by nation again.
4. 16TRK/8TRK2 Initial problem.
=> When 16TRK/8TRK2 is on initial phase, if trunk gain parameters are downloaded and system reset the slot, then initialization is failed. So we modify TRK initial phase to block slot reset when LP40 download trunk gain parameters.
5. TEPRI2 did not work correctly sometimes.
=> 1st 32 ports and 2nd 32 ports of TEPRI2 can be set separately. But all messages have been sent only to 1st part. In this condition the card does not work correctly. So we modify message service routine to separate message.
6. PRS3 hangs up call on answer.
=> Base polarity value was stored before ringing state. But in PRS3 mode it is necessary the value to be stored after answer. We modify system store the base polarity value after answer.